This installation of TCS MC2 Decoder is for HO Scale Rivarossi 0-6-0 Saddle Tank and was performed by Claude Quesnelle of Candiac Quebec, Canada.
Photos and text by Claude Quesnelle of Candiac Quebec, Canada.
Decoder Installation in HO Rivarossi 0-6-0 Saddle Tank Engine: Item #1286 Reliance Rock Co. #1
Please do not use any flux either liquid or paste on the mother board. Over time, the acidic properties of liquid or paste flux will begin eating away at the fiberglass PCB and will damage it. Use only Rosin-core solder or no-clean flux approved for electronics use.
TCS recommends the use of Kester "44" Sn63 Pb37, .015" diameter Rosin-core solder. Kester part number 24-6337-0007.
You can order this solder from the following retailers:
Digikey - PN:KE1110-ND
Techni-Tool - PN:488SO6775
When stripping wire, only strip a tiny little bit of the insulation. Strip no more than a 1/32 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire than half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire