Athearn GTEL X-51

Scale:
HO Scale


This installation uses the following decoder:

T1



This installation of TCS T1 Decoder is for HO Scale Athearn GTEL X-51 and was performed by TCS.

Shown with the shell on.
Shown with the shell on.
Front of the locomotive.
Front of the locomotive.
Back of the locomotive.
Back of the locomotive.
One of the screws that needs to be removed.
One of the screws that needs to be removed.
There is a total of 4 screws on both sides of the locomotive, that need to be unscrewed prior to shell removal.
There is a total of 4 screws on both sides of the locomotive, that need to be unscrewed prior to shell removal.
Grasping the shell by the solid area between the grills, lift the shell straight up and off of the chassis.
Grasping the shell by the solid area between the grills, lift the shell straight up and off of the chassis.
Remove the original DCC plug that came with the locomotive by gently sliding it off of the socket.
Remove the original DCC plug that came with the locomotive by gently sliding it off of the socket.
Plug our T1 decoder in as shown in the picture above. Hold the shell in one hand and the chassis in your other hand. Lining up the front of both pieces, lower the shell onto the chassis, keeping the lower edge of the shell parallel with the chassis.
Plug our T1 decoder in as shown in the picture above. Hold the shell in one hand and the chassis in your other hand. Lining up the front of both pieces, lower the shell onto the chassis, keeping the lower edge of the shell parallel with the chassis.

Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. Over time, the acidic properties of liquid or paste flux will begin eating away at the fiberglass PCB and will damage it. Use only Rosin-core solder or no-clean flux approved for electronics use.

TCS recommends the use of Kester "44" Sn63 Pb37, .015" diameter Rosin-core solder. Kester part number 24-6337-0007.

You can order this solder from the following retailers:
Digikey - PN:KE1110-ND
Techni-Tool - PN:488SO6775

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more than a 1/32 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire than half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire