Athearn Genesis SD70

Scale:
HO Scale


This installation uses the following decoder:

A6X



 

This installation is for HO-Scale Athearn Genesis SD-70 uses TCS A6X Digital Decoder and was performed by A.G.

Shown with the shell on prior to installations.
Shown with the shell on prior to installations.
Front of the locomotive.
Front of the locomotive.
Back of the locomotive.
Back of the locomotive.
Unscrew the front screw (circled in red) as well as the back one that holds the coupler pockets to the chassis and remove both coupler pockets.
Unscrew the front screw (circled in red) as well as the back one that holds the coupler pockets to the chassis and remove both coupler pockets.
Grasping the shell by the solid area between the grills, lift the shell straight up and off of the chassis. Be careful not to break the wires for the lights.
Grasping the shell by the solid area between the grills, lift the shell straight up and off of the chassis. Be careful not to break the wires for the lights.
Desolder all wires that come to the original light board, remove the original light board.
Desolder all wires that come to the original light board, remove the original light board.
Using the manual that came with A6X decoder solder wires to the decoder's pads.
Using the manual that came with A6X decoder solder wires to the decoder's pads.
Hold the shell in one hand and the chassis in your other hand. Lining up the front of both pieces, lower the shell onto the chassis, keeping the lower edge of the shell parallel with the chassis. Do not forget to attach both couplers.
Hold the shell in one hand and the chassis in your other hand. Lining up the front of both pieces, lower the shell onto the chassis, keeping the lower edge of the shell parallel with the chassis. Do not forget to attach both couplers.

Important Soldering Tip

Please do not use any flux either liquid or paste on the mother board. Over time, the acidic properties of liquid or paste flux will begin eating away at the fiberglass PCB and will damage it. Use only Rosin-core solder or no-clean flux approved for electronics use.

TCS recommends the use of Kester "44" Sn63 Pb37, .015" diameter Rosin-core solder. Kester part number 24-6337-0007.

You can order this solder from the following retailers:
Digikey - PN:KE1110-ND
Techni-Tool - PN:488SO6775

Other solder tips

When stripping wire, only strip a tiny little bit of the insulation. Strip no more than a 1/32 of an inch. When the wire gets tinned with solder, the insulation will shrink back more. Try to not expose any more wire than half the length of the solder pad at most. In no case should solder or exposed wire wire ever be outside the boundary of the the solder pad you are attaching a wire to.
Click here for important information on properly Stripping and Tinning wire